Your Assignment is to write a 700 word summary of ONE of the journal articles provided in the module. Follow
the instructions below for reading, understanding, and writing your paper. Be sure to cover all the items listed as
they pertain to the article. Be sure to condense your work so you do not exceed the word count, but include all
the required information.
Summarizing a Research Article
Research articles use a standard format to clearly communicate information about an experiment. A
research article usually has seven major sections: Title, Abstract, Introduction, Method, Results,
Discussion, and References. Sometimes there are minor variations, such as a combined Results and
Discussion section, or an overall General Discussion section in which multiple experiments are
presented in one article.
Reading the Article
Allow enough time. Allot at least half the time that you spend on this assignment to reading and
understanding the article. Before you can write about the research, you have to understand it. This
takes more time than most students realize. Does the author’s study make sense to you in lay terms
(could you explain the study to your roommate)? When you can clearly explain the study in your own
words, then you are ready to write about it. Here’s how to proceed.
Scan the article first. If you try to read a new article from start to finish, you’ll get bogged down in
detail. Instead, use your knowledge of APA format to find the main points. Briefly look at each
section to identify:
|the research question and reason for the study (stated in the Introduction)
the hypothesis or hypotheses tested (Introduction)
how the hypothesis was tested (Method)
the findings (Results, including tables and figures)
how the findings were interpreted (Discussion)
Underline key sentences or write the key point (e.g., hypothesis, design) of each paragraph in the
margin. Although the abstract can help you to identify the main points, you cannot rely on it
exclusively, because it contains highly condensed information.
Read for depth, read interactively. After you have highlighted the main points, read each section
several times. As you read, ask yourself these questions:
|How does the design of the study address the question posed?
What are the controls for each experiment?
How convincing are the results? Are any of the results surprising?
What does this study contribute toward answering the original question?
What aspects of the original question remain unanswered?
Plagiarism. Plagiarism is always a risk when summarizing someone else’s work. To avoidit:
|Take notes in your own words. Avoid writing complete sentences when note-taking.
Summarize points in your own words. If you find yourself sticking closely to the original
language and making only minor changes to the wording, then you probably don’t understand
the study (see our handout, “Plagiarism and Student Writing”).
Copyright 2010, University of Washington summarizing.pdf
Writing the Summary
Like an abstract in a published research article, the purpose of an article summary is to give the reader
a brief, structured overview of the study. To write a good summary, identify what information is
important and condense that information for your reader. The better you understand a subject, the
easier it is to explain it thoroughly and briefly.
Write a first draft. Use the same order as in the article itself. The number of suggested sentences given
in parentheses below is only a rough guideline for the relative length of each section. Adjust the length
accordingly depending on the content of your particular article.
|State the research question and explain why it is interesting (2-3 sentences).
State the hypothesis/hypotheses tested (1-3 sentences).
Briefly describe the methods (design, participants, materials, procedure, what was manipulated
[independent variables], what was measured [dependent variables], how data were analyzed
Describe the results. What differences were significant? (2-3sentences).
Explain the key implications of the results. Avoid overstating the importance of the findings (2-3
The results, and the interpretation of the results, should relate directly to the hypothesis.
For the first draft, focus on content, not length (it will probably be too long). Condense later as needed.
Try writing about the hypotheses, methods and results first, then about the introduction and discussion
last. If you have trouble on one section, leave it for a while and try another.
Edit for completeness and accuracy. Add information for completeness where necessary. More
commonly, if you understand the article, you will need to cut redundant or less important information.
Stay focused on the research question, be concise, and avoid generalities. The Methods summary is
often the most difficult part to edit. See the questions under ‘Reading interactively’ to help you decide
what is important to include.
Edit for style. Write to an intelligent, interested, naive, and slightly lazy audience (e.g., yourself, your
classmates). Expect your readers to be interested, but don’t make them struggle to understand you.
Include all the important details; don’t assume that they are already understood.
|||Eliminate wordiness, including most adverbs (“very”, “clearly”). “The results clearly showed
that there was no difference between the groups” can be shortened to “There was no significant
difference between the groups”.
Use specific, concrete language. Use precise language and cite specific examples to support
assertions. Avoid vague references (e.g. “this illustrates” should be “this result illustrates”).
Use scientifically accurate language. For example, you cannot “prove” hypotheses (especially
with just one study). You “support” or “fail to find support for” them.
Rely primarily on paraphrasing, not direct quotes. Direct quotes are seldom used in
scientific writing. Instead, paraphrase what you have read. To give due credit for information
that you paraphrase, cite the author’s last name and the year of the study (Smith, 1982). (See
our “APA Citations” handout.)
Re-read what you have written. Ask others to read it to catch things that you’ve missed.